This switch is ideal for solar installations or where battery backup is required.
Five (5) 802.3af/at PoE Ports, two (2) 24/48 V selectable PoE Ports, and one (1) SFP Port.
You connect:
- [optional] Solar panel (not included)
- [optional] 12 or 24 V Battery (not included. Lead-acid, or Lithium (Li-ion, or LiFePO4 with BMS)
- [optional] DC Power supply (not included)
- A mix of 24 and 48 V POE devices.
The battery is charged if one or both of the Solar or DC inputs is/are active.
Features
- 3 Year, return to Australia warranty
- All metal construction
- Supports both Lead-Acid and Lithium batteries (Li-ion, or LiFePO4 with BMS)
- 1 High-Power 802.3bt, Type-3 PoE port (60 W). Compatible with Hi Power cameras from Hikvision, Dahua, UNV, and others.
- 5 Gigabit PoE Ports
- 1 SFP Port (Confirmed to work with Ubiquiti UF-RJ45-1G)
- PoE power outputs:
- Port 1: 48 V 802.3af/at/bt PoE, 60 W
Pins 1,2,4,5 (+), 3,6,7,8 (-)
- Ports 2-3: 48 V 802.3af/at PoE, 30 W.
Pins 1,2 (+), 3,6 (-)
- Ports 4-5: Switch selectable 24 or 48 V PoE Ports
Compatible with both 802.3af/at 48 V and passive 24 V powered devices.
48 V selected: 802.3af/at, 48 V, 30 W PoE, Pins 1,2 (+), 3,6 (-)
24 V selected: 24 V, 30 W PoE, Pins 4,5 (+), 7,8 (-)
- Power Input Options (not included):
- [optional] Solar Panel:
- For 12V Battery: ≤32V, ≤ 150W.
- For 24V Battery: ≤45V, ≤ 300W
- [optional] Battery: 12V or 24V, 5~100 Ah (Note: The datasheet gives a max battery capacity of 50 Ah. This is incorrect.)
- [optional] DC IN: For 12V Battery: DC 15-26V. For 24V Battery: DC 30-36V
- Integrated MPPT battery controller, preventing battery over-charge and over-discharge
- IEEE 802.3af/at/bt PoE
- Quiet fanless operation
- Suitable for 48V 802.3af/at/bt and 24 V PoE powered devices like many wireless APs, IP-cameras, VoIP phones, etc.
- Grounded RJ45 sockets compliant with Ubiquiti grounding requirements
- DIP switches - Front
- Fiber Watchdog. If the SFP datalink goes down for 30 seconds, the switch re-starts the SFP port.
- VLAN. The RJ45 ports are isolated from each other, but not the SFP port. This provides "Client Isolation''.
- EXTEND. Normally, Ethernet cable runs are limited to 100 m. With EXTEND turned on, the maximum speed is dropped to 10 Mbps, but the ethernet cable can be 250 m.
- Ports 4/5: Manual selection of PoE voltage. 24 V (pins 4,5,7,8), or 48 V (pins 1,2,3,6).
- DIP switches - Rear
- System power: On / Off
- Battery type: Lead-Acid, or LiFePO4 with BMS / Li-ion
- Battery voltage: 12 / 24 V
- Lithium Battery type: Standard / Ternary polymer (ignored if DIP 2 = Lead-Acid)
Specifications
Switching Capacity | 20 Gbps
|
---|
Packet Forwarding Rate | 8.94 Mpps
|
---|
PoE ports | 5 x Gigabit Ethernet
|
---|
PoE output voltage | 48V (5 ports max), and 24V (2 ports max.)
|
---|
PoE power output | 120 W max.
|
---|
Uplink Ports | 1 x SFP
|
---|
Power consumption switch alone | 2 W
|
---|
Solar charger type | MPPT
|
---|
Battery Charge current | 5 A max.
|
---|
Battery Charge power | 60 W (12 V battery) 120 W (24 V battery)
|
---|
Battery Voltage | 12 V or 24 V (switch selectable)
|
---|
Battery Capacity | 5 to 100 Ah
|
---|
Battery Type | Lead-Acid, LiFePO4 with BMS, or Li-ion
|
---|
Operating temperature range | -20℃ ~ 60℃
|
---|
Dimensions | 160 x 140 x 33 mm (L x W x H)
|
---|
Solar Panel | 12V Battery: ≤32V,≤150W. 24V Battery: ≤45V,≤300W
|
---|
Guides
Battery/Panel Sizing Guide
The table below assumes:
- 24 hrs operation required
- 8 hrs solar charging
PoE Load (Watts) | Battery | Solar Panel
|
---|
8 | 12 V, 30 Ah 24 V, 15 Ah | 12 V, 100 W 24 V, 100 W
|
13 | 12 V, 40 Ah 24 V, 20 Ah | 12 V, 150 W 24 V, 150 W
|
18 | 24 V, 30 Ah | 24 V, 200 W
|
Suggested Method to Power by AC
A Ubiquiti PoE injector, and a simple patch lead, can be used as a convenient AC power supply for this switch when used with no battery or a 12 V battery. The total available power will be limited to the power rating of the PoE injector (24 W in this case).
The 24V, 24W PoE is an ideal choice.
|
| Then make a PoE cable wired as follows:
RJ45 Pins | WI-PS306G-UPS |
4 & 5 | V+ |
7 & 8 | V- |
Shell Ground | Ground |
|
Shipping Weights & Dimensions for 1 carton of 20 each
Dimensions: 53 x 53 x 40 cm
Volume: 0.1124 m3
Volumetric Weight: 28.1 kg
Dead Weight: 20.00 kg